Yes the gates should be closed APPLICATION Lifting goods between levels PIT INSTALLED YES QUANTITY 1 OFF CONSTRUCTION High Lift Scissor Table MODEL / TYPE RLXY3-20/430-2C CAPACITY 2000KG — evenly distributed load TRAVEL / STROKE 4400mm (limit switch set at 4300mm) CLOSED HEIGHT 750mm – pit dimensions to be advised at PDI TOTAL RAISED HEIGHT 5050mm PLATFORM SIZE 2200mm long & 1790mm wide, with anti slip surface (tear plate) OPERATION 2,3 kW compact electro-motor with hydraulic pump unit and adequately sized oil tank wired to IP55 Standard. Power unit is located outside the Lift POWER SUPPLY 400 Volts, 3 phases, 50 Hz CONTROL VOLTAGE 24 Volts with IP55 insulated electrics TRAVEL SPEED Approximately 75 seconds to maximum height CYLINDERS Normally single acting precision made units complete with pipe break valve to prevent a rapid lowering speed in the unlikely event of a hydraulic hose failure. Delfleet anti corrosion, ETCH-Primer. WEIGHT Approximately 1500KG’s STANDARD FINISH Stainless Steel AISI304 platform, gates and handrails Mild steel RAL 9005; base frame and scissors Mild steel; axles, wheels and bolts CONTROLS Two (2) constant pressure UP & DOWN hand control units with EMERGENCY STOP button and 6 meter long cable SAFETY TRIP BAR Aluminium safety frame with built in safety function. If the safety frame is touched on its way down, the Lift stops immediately. To continue lowering, the table has to be raised a little to be able to lower again. MAINTENANCE Standard …